1·Finally, Dad turned off the stove, the pot began to cool and the pressure relief valve sprayed out a cloud of steam.
最后，爸爸关上了炉子，锅开始降温，然后解压阀喷出了一股水汽。
2·Regulate the relief valve.
调整安全阀。
3·Damage or fouled relief valve seat.
安全阀阀座损坏或受到污染。
4·Damaged or fouled relief valve seat.
安全阀阀座受到损坏或污染。
5·Remove the pressed in relief valve seat and seat O-ring.
拆卸压进去的安全阀阀座和阀座o形环。
6·An O-ring seals the relief valve body to the main housing.
用一个O形环密封安全阀阀体与主外壳。
7·Clean, adjust relief valve -, check for worn and dirty valve.
清洁，调节安全阀，检查是否有磨损和肮脏的阀门。
8·Thoroughly clean all inside surfaces of the relief valve body.
彻底清洗安全阀阀体的所有内部表面。
9·With an asynchronous model, the queue itself ACTS as a relief valve.
借助异步模型，队列本身可以充当一个减压阀。
10·Remove the relief valve hose from fitting below inlet ball valve.
从进口球阀下面连接件拆卸安全阀软管。
1·Caution: Relief valve will discharge hot water, therefore precautions must be taken to avoid scalding injury or water damage.
警告：安全阀将会排放热水，因此必须采取预防措施防止烫伤和水损害。
2·A drain line should be attached to the relief valve to channel any potential discharge to a safe place of disposal.
在安全阀上应该连接排水管道，将任何可能的排放引导到安全的处置地方。
3·The installation of a Watts air gap with the drain line terminating above a floor drain will handle any normal discharge or nuisance spitting through the relief valve.
连接通向地漏的排泄管的美国瓦茨气隙的安装将有助于处理通过安全阀排出的任何正常排放或有害的泄漏。
4·Water discharge from the relief valve should be vented in accordance with code requirements.
从安全阀出来的排放水应该按照规程的要求进行排放。
5·Damage or fouled relief valve seat.
安全阀阀座损坏或受到污染。